MB Slim Watch, Click for more information
Becker Radio Removal
The following explains how to remove various trim pieces and
ultimately
the Becker radio.
Remove the ash tray insert. Remove the two screws deep inside.
Starting with the top edge, carefully pry up the shift hole trim.
It is
secured by four tabs as shown. For installation make
sure these tabs
fit back into their slots.
Remove two screws from inside roll-top storage bin.
Remove storage
bin.
Remove one screw that secures back part of wood trim.
Carefully wiggle/pry
the horizontal wood trim piece up,
grasp it from the back. You are
trying to slowly wiggle the
side mirror and fader controls out of their
sockets. These
will remain attached to the trim while the window
switches
will remain attached to the console. 
Once loose you can pull the whole piece out and set it aside.
Be aware of
the holding tabs at the top of the piece.
Once the horiz. wood trim is out you can remove the whole
ash tray
assembly. The only thing holding it in is some
wiring that can be
easily unplugged.
With the ash tray assembly gone you can now see two plastic
tabs under
each side of the Becker. Push and hold down
these tabs and wiggle the
radio out. I was able to grasp the
radio from the bottom of the tape door
push one tab and slide
one side out a bit. Then the other tab/side a
bit and then the
whole thing slide out. Be careful you don't bust the
tape door.
Here is the back of the radio and it's wiring in case you ever
need to
reinstall the Becker.